NGHIÊN CỨU ỔN ĐỊNH CỦA TẤM FGM CÓ VẬT LIỆU PHÂN BỐ KHÔNG LIÊN TỤC

Tóm tắt

Nghiên cứu này sử dụng phương pháp phần tử hữu hạn để trình bày nghiên cứu về ổn định của tấm có cơ tính biến thiên (FGM) tựa trên nền đàn hồi hai hệ số, tuy nhiên sự phân bố của vật liệu không liên tục từ mặt này đến mặt kia của tấm. Các biểu thức tính toán được thiết lập từ lý thuyết biến dạng cắt kiểu mới, sau đó dựa trên nguyên lý công khả dĩ để tìm ra phương trình cân bằng cho tấm chịu tải trọng nén, phần tử bốn nút, mỗi nút sáu bậc tự do được bài báo sử dụng để giải quyết phương trình cân bằng vừa tìm được. Sự tin cậy của phương pháp tiếp cận được kiểm chứng bằng cách so sánh với các kết quả đã công bố. Bài báo cũng tiến hành khảo sát ảnh hưởng của các tham số hình học, sự phân bố vật liệu, điều kiện biên và độ cứng nền đến đáp ứng ổn định của tấm này, đây là tài liệu tham khảo có giá trị để tìm ra các tham số thiết kế phù hợp cho tấm FGM để khả năng chịu tải của tấm là tốt nhất. 

Từ khóa:

Ổn định của tấm; Không liên tục; Phương pháp phần tử hữu hạn.

Title

STABILITY STUDY OF FGM PLATES WITH DISCONTINUOUS MATERIAL DISTRIBUTION

Abstract

This study uses the finite element method to present the study of the stability of a plate with variable mechanical properties (FGM) resting on a two-factor elastic foundation, but the distribution of the material is not continuous from one side to the other of the plate. The calculation expressions are established from the new shear deformation theory, then based on the principle of possible work to find the equilibrium equation for the plate under compressive load, the four-node element, each node has six degrees of freedom, is used in the article to solve the equilibrium equation just found. The reliability of the approach is verified by comparison with published results. The paper also investigates the influence of geometric parameters, material distribution, boundary conditions and foundation stiffness on the stability response of this plate, which is a valuable reference for finding suitable design parameters for FGM plates to achieve the best load-bearing capacity of the plate

Keywords:

Stability of plates; Discontinuous; Finite element method.

Tải xuống

Ngày nhận bài:

18-02-2025

Ngày phản biện:

10-03-2025

Ngày nhận bài sửa:

13-03-2025

Ngày duyệt đăng:

15-03-2025

Ngày xuất bản:

25-04-2025
NGHIÊN CỨU – TRAO ĐỔI
Lượt xem
0
Lượt tải
0